22285 Autoloader 2 ALE2: Unable to calibrate media slipsheet threshold Trendsetter_VLF_Auto This is reported during the monitor command "cal sst" for one of the following reasons: consecutive readings of the same point on the plate or slipsheet, vary too much, sensor may be faulty. See diag monitor for values. slipsheet reading is too close to plate reading (probably no slipsheet there) slipsheet reading is > 800 (probably looking at the empty cassette ) picker sensor, slipsheet handling sensors disable or slipsheet handling not installed Set verbose monitor 1 for details Not applicable. see service info. ../nvs/media_cal_sst.xmlNVS: media sst ../commands/cal_sst.xmlCommand: cal sst ../commands/cal_picker.xmlCommand: cal picker ../commands/picker_ss_sensor.xmlCommand: picker ss sensor ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:34:03 2008 PST